How to measure
- Measure the total rise: from the ground or walkway at the bottom of the steps straight up to the top landing level.
- Decide the tread depth (front to back) and the width of the steps.
- At a door, plan a top landing at least 36 in deep. Set it to 0 if the steps meet an existing porch or slab.
How the concrete steps calculation works
Risers = ceil(total rise ÷ max riser); riser = total rise ÷ risers Treads = risers − 1 with a landing (the landing is the top step), else risers Steps = width × tread × riser × t(t + 1) ÷ 2 Landing = width × landing depth × total rise Order = (steps + landing) × (1 + waste)
Solid poured steps are a stack of blocks: the bottom step is one riser tall, the next two, and so on. Adding them gives the triangular-number formula t(t + 1) ÷ 2. The landing sits at the full height.
The layout uses the IRC limits: risers no taller than 7¾ in, treads at least 10 in, stairs at least 36 in wide, and landings at least 36 in deep in the direction of travel.
Worked example
A 21 in rise to a back door, 11 in treads, 48 in wide, with a 36 in landing and 80 lb bags.
- Risers: 21 ÷ 7.5 = 2.8 → 3 risers of 7 in; 2 treads plus the landing
- Steps: 48 × 11 × 7 × 2 × 3 ÷ 2 = 11,088 cu in
- Landing: 48 × 36 × 21 = 36,288 cu in; total 47,376 cu in = 27.4 cu ft (1.02 cu yd)
- With 10%: 30.2 cu ft ÷ 0.6 cu ft per bag = 50.3 → 51 bags
You need about 1.12 cu yd with waste — 51 bags of 80 lb premix, or a 1¼ yd ready-mix order.
How much extra to allow
Forms bulge and the ground under the bottom step is rarely flat, so order 5–10% extra.
| Situation | Allow |
|---|---|
| Tight, braced forms | 5% |
| Typical DIY forms | 10% |
Reading your result
Every riser comes out identical — the calculator divides the total rise evenly, which is what the code's ⅜ in variation limit requires.
Above about 1½ cubic yards, ready-mix is usually cheaper and much faster than mixing bags.
Assumptions
- Steps are solid concrete; formed hollow steps or steps poured against a wall use less.
- Riser, tread, width and landing limits are from the 2021 IRC (R311.7); your town may amend them.
- An 80 lb bag of premix yields 0.60 cu ft.
Unit conversions use exact definitions (1 in = 25.4 mm, 1 US gal = 3.785 L). See the calculation methodology for rounding rules.
When to call a professional
- In cold climates, steps attached to a house need footings below the frost line or they heave. Check your local footing and handrail requirements before pouring.
Frequently asked questions
How much concrete do I need for 3 steps?
For three 7 in risers, 11 in treads, 4 ft wide with a 3 ft landing: about 27 cu ft (1 cu yd) before waste — roughly 51 bags of 80 lb premix with 10% extra.
What is the maximum step height for outdoor stairs?
The IRC limits risers to 7¾ in (196 mm) with treads at least 10 in (254 mm), and riser heights may vary by no more than ⅜ in within a flight. Local codes can differ.
How big does the landing at a door need to be?
At least as wide as the door it serves and 36 in deep in the direction of travel under the IRC.