How to measure
- Measure each room wall to wall at the widest and longest points, into door openings to where the carpet will end. Round up to the next inch.
- Add closets as separate rooms if they get the same carpet.
- Count the doorways where the carpet meets another floor — each gets a transition strip and no tack strip.
- Check the roll width with your store. 12 ft is standard; some styles come in 13 ft 6 in or 15 ft.
How the carpet calculation works
Strips = room width ÷ roll width, rounded up Strip length = room length + trim at both ends Off the roll = strips × strip length (tried both directions, shorter kept) Carpet (sq yd) = off the roll × roll width ÷ 9 Pad (sq yd) = floor area × 1.05 ÷ 9 Tack strip = room perimeter − 3 ft per doorway
Carpet isn't bought by floor area. It's cut from a roll of fixed width, so a room 13 ft wide needs two 12 ft-wide strips, and the second strip is mostly offcut. That's why the yardage you order is always more than the floor area.
The calculator lays strips both ways in each room and keeps the direction that buys less carpet. Every strip gets a few inches extra at each end so the installer can trim it to the wall.
Pad is laid wall to wall inside the tack strip, so it follows the floor area plus a little for trimming. Tack strip runs around the room except across doorways.
Worked example
A 14 × 12 ft bedroom with one doorway, carpet from a 12 ft roll with 3 in trim at each end.
- Floor area: 14 × 12 = 168 sq ft
- Strips along the 14 ft wall: 12 ÷ 12 = 1 strip, no seam
- Strip length: 14 ft + 3 in + 3 in = 14.5 ft
- Carpet: 14.5 × 12 = 174 sq ft ÷ 9 = 19.3 sq yd
- Pad: 168 × 1.05 = 176.4 sq ft = 19.6 sq yd
- Tack strip: 2 × (14 + 12) − 3 = 49 ft → 13 four-foot sticks
Order 14 ft 6 in off a 12 ft roll — about 19.3 sq yd of carpet — plus 19.6 sq yd of pad and 13 sticks of tack strip.
How much extra to allow
There's no waste percentage to choose: the roll width sets the waste. A room that fits the roll exactly wastes only the trim; a room just over 12 ft wide can waste far more unless a wider roll or a different strip direction avoids the seam.
| Situation | Allow |
|---|---|
| Room width close to the roll width | 3–10% over floor area |
| Room much narrower than the roll | 20% or more — use the offcut in a closet |
| Room just over the roll width | 40–70% — try a 13 ft 6 in or 15 ft roll |
Reading your result
Square yards is how carpet is priced. 'Length off the roll' is what the store actually cuts — compare it with the order you're quoted.
The 'Cuts by room' table shows how many strips each room needs and which wall they run along. Seams fall between strips.
If a room shows a narrow fill strip, ask the installer whether it can come from another room's offcut. That can save a few yards.
Assumptions
- Rooms are rectangles. Split L-shaped rooms into two rectangles; the result is a little conservative because real installers can fill corners from offcuts.
- Every strip is bought at full roll width. Narrow fill pieces cut from another strip's leftover are not credited.
- Pile runs the same way in every strip. Patterned carpet needs extra length per strip to match the repeat — check the repeat on the sample.
- Pad is floor area plus 5%. Tack strip comes in 4 ft (1.2 m) sticks; doorways are 3 ft wide.
Unit conversions use exact definitions (1 in = 25.4 mm, 1 US gal = 3.785 L). See the calculation methodology for rounding rules.
When to call a professional
- Stairs, patterned carpet and rooms needing seams in visible places are worth leaving to a professional installer with a power stretcher.
- Most retailers re-measure before cutting. Use this estimate to check their quote, not to place the final order.
Frequently asked questions
How many square yards of carpet do I need for a 12 × 12 room?
The floor is 16 sq yd. Off a 12 ft roll with 3 in trim at each end you'd order 12.5 ft × 12 ft = 150 sq ft, about 16.7 sq yd.
How do I convert square feet to square yards?
Divide by 9. A square yard is 3 ft × 3 ft, so 168 sq ft is 18.7 sq yd.
Why is my carpet order bigger than my floor?
Carpet comes off a fixed-width roll. If a room is 13 ft wide, you pay for two 12 ft strips even though the second is mostly offcut. Trim at the walls adds a little more.
Which way should carpet seams run?
Seams should run toward the main light source (usually a window) and away from doorways and walkways, with the pile in every strip pointing the same way.
How much carpet pad do I need?
About the floor area plus 5% for trimming. For a 14 × 12 ft room that's 19.6 sq yd.