Skip to content
MeasureToBuy

Crown Molding Calculator

Enter each room's length and width. You'll get the linear feet of crown molding around the ceiling, the stock lengths to buy with waste for compound cuts, and the corners to cope or miter.

Measurements

Corners that stick out into the room, e.g. around a chimney breast or a wall return.

Lengths you'll buy

Longer lengths mean fewer joints on long walls. Check what your store stocks.

Waste allowance

Rule of thumb for miter and cope cuts and short offcuts you can't use.

Your estimate

You need 4 pieces of 16 ft crown molding.

52 ft of crown molding plus 15% waste.

Room perimeter
52 ft
Crown molding length
52 ft
Waste allowance
15%
Length to buy
59.8 ft
16 ft pieces
4 pieces

Corners

Inside corners
4 corners
Outside corners
0 corners
  • Buying by the total length assumes offcuts are reused. Count it wall by wall if you want no joints on walls shorter than 16 ft.

Next step

Doing the baseboard as well?

The same rooms carry over; doors are deducted at the floor.

Baseboard calculator

How to measure

  1. Measure each room's length and width at the ceiling — doors don't interrupt crown.
  2. Count outside corners where the ceiling line turns outward, such as around a chimney breast or soffit.
  3. Note the molding's spring angle (often 38° or 45°) on the label; you'll need it to set the saw.

How the crown molding calculation works

Crown  = Σ room perimeters
To buy = crown × (1 + waste)
Pieces = to buy ÷ stock length, rounded up
Inside corners = 4 per room + outside corners

Unlike baseboard, crown runs unbroken around the ceiling, so nothing is deducted for doors.

Crown is cut at compound angles and a mistake usually means a new piece, so the default waste is higher than for baseboard.

Worked example

A 14 × 12 ft room in 16 ft lengths with 15% waste.

  1. Perimeter: 2 × (14 + 12) = 52 ft
  2. With waste: 52 × 1.15 = 59.8 ft
  3. Pieces: 59.8 ÷ 16 = 3.7 → 4 lengths

Buy 4 lengths of 16 ft crown molding and plan 4 inside corners.

How much extra to allow

Each corner needs two angled cuts, and test cuts are common until the saw is set. Coping inside corners wastes a little less than mitering.

SituationAllow
Experienced, coped corners10%
Typical15%
First project, many corners20%

Reading your result

Order the pieces shown. Long walls look best with one continuous length — buy a longer stock length rather than splicing if you can.

Hold crown upside down and backwards on the miter saw ("ceiling on the table, wall on the fence") if you aren't using compound settings.

Assumptions

  • Rectangular rooms; enter bump-outs as separate rooms or count their outside corners.
  • Offcuts reused on short walls.
  • Waste is a rule of thumb; compound miters waste more than baseboard cuts.

Unit conversions use exact definitions (1 in = 25.4 mm, 1 US gal = 3.785 L). See the calculation methodology for rounding rules.

Frequently asked questions

How much crown molding do I need for a room?

The room's perimeter plus about 15%. A 12 × 14 ft room has a 52 ft perimeter, so buy about 60 ft — four 16 ft lengths.

Do you subtract doors for crown molding?

No. Crown runs along the ceiling above doors and windows, so measure the full perimeter.

Should I cope or miter crown corners?

Cope inside corners when walls aren't perfectly square — the joint stays tight as the house moves. Outside corners are mitered.

More lumber & carpentry calculators

All lumber & carpentry